Forum: The 'Original' BASE Board - Public BASE Jumping discussion Forum.
Discuss VTEC packing at the The 'Original' BASE Board within the BASE jumping :: BASEJumping.tv @ BLiNC Magazine; I have ordered a FOX with VTEC and wanted to know if people pack their ... (on showthread pages)
      
Reply to Thread
Results 1 to 10 of 10
  1. #1 VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    I have ordered a FOX with VTEC and wanted to know if people pack their canopies differently from those without the VTEC option. Obviously, I expect the manual from BR to give specific advice. Also, when packing a VTEC, should any special consideration be given to terminal or short delays?

    Meeker :D
    Reply With Quote  
     

  2. #2 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    leave it packed in its box, send it back and order a blackjack
    Reply With Quote  
     

  3. #3 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Sep 2001
    Posts
    904
    I pack my Vtec FOX exactly as I packed my standard FOX. I just ignore the vents while packing.

    Some people find that terminal openings with the Vtec modification are unacceptably (rolling the nose, sail slider, etc). I do find them harder than standard FOX openings, but still acceptable, so I don't change my pack job there either.

    --Tom Aiello
    tbaiello@ucdavis.edu
    Reply With Quote  
     

  4. #4 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    I don't pack my Vtec any different than a non-Vtec canopy.

    For terminal - in general, using a mesh slider gives better on-heanding performance, so I never use a sail. Some don't like the harder openings, but I don't mind going lower for a marginally harder opening with better on-heading performance using mesh (although a certain little pink tasmanian smacky bastard calls me a dirty high puller whenever he can...). Were we talking about the Vtec or sliders?

    Anyway, the Vtec adds very little to the abruptness of the opening on terminal jumps, and is good for sub-terminal slider up jumps - basically giving slightly quicker pressurization.

    I always pack my slider off Vtec with the center cell nose exposed - wraped around half the canopy. Again, harder opening, but definately worth the quicker pressurization.

    :-)
    Reply With Quote  
     

  5. #5 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    ........and wait, and wait, and wait.........:P
    Reply With Quote  
     

  6. #6 RE: VTEC packing 
    460
    460 is offline
    Staff Member
    Join Date
    Dec 1969
    Posts
    197
    I use a VTEC all the time at terminal but it requires you do everything you can to reef the opening. On my first jump on the VTEC, I climbed to 1300' and did about a 7.5 second delay. The canopy was packed with a rolled nose, indirect slider control, and a mesh slider. The opening was so hard, I badly bruised my chest with my chin and suffered a mild concussion. I was recommended to get an MRI for my neck(which I didn't bother with). I thought I might have had an improper opening sequence. However, similarly hard openings happened a couple more times later on. The openings are now OK now the canopy is not as new. I definetely recommend a good locking stow, direct slider control perhaps with a double wrap depending on how you feel, and rolling the nose. Regarding the question of a sail slider, you can always have a sail slider made with a hole (covered with mesh) in it if the openings are still too hard and you don't want a full sail slider. I personally prefer something like the Raven's bikini-style sail slider. BSBD - Chris

    Reply With Quote  
     

  7. #7 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    see my comment above for the best packing advice
    Reply With Quote  
     

  8. #8 RE: VTEC packing 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    I thought Blackjack was a condom.:o
    Reply With Quote  
     

  9. #9 ZP top skin 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    V-tec with ZP top skin......

    is this the same or does it change things much?
    Reply With Quote  
     

  10. #10 RE: ZP top skin 
    I Support BLiNC Magazine (Silver) crwper's Avatar
    Join Date
    Dec 1969
    Location
    Perigee Pro
    Posts
    381
    I think this makes openings a bit quicker.

    Michael
    Reply With Quote  
     

Similar Threads

  1. Vtec
    By Faber in forum The 'Original' BASE Board
    Replies: 13
    Last Post: December 30th, 2002, 08:53 AM
  2. Packing a Fox Multi-Vtec...
    By BASE_689 in forum The 'Original' BASE Board
    Replies: 3
    Last Post: September 21st, 2002, 12:17 PM
  3. Question about FOX vTec + Multi
    By PerFlare in forum The 'Original' BASE Board
    Replies: 17
    Last Post: May 28th, 2002, 06:48 AM
  4. landing VTEC
    By guest in forum The 'Original' BASE Board
    Replies: 2
    Last Post: October 20th, 2001, 07:38 AM
  5. Vtec at terminal
    By guest in forum The 'Original' BASE Board
    Replies: 7
    Last Post: November 26th, 2000, 10:52 AM

Visitors found this page by searching for:

vtec hela tiden

vtec en francais

vtec as gaeilgevtec packingvtec french
SEO Blog
Tags for this Thread

View Tag Cloud

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83