Forum: The 'Original' BASE Board - Public BASE Jumping discussion Forum.
Discuss Altitude question at the The 'Original' BASE Board within the BASE jumping :: BASEJumping.tv @ BLiNC Magazine; Object: 600' stack, elevator, nice landing area. Problem-Security. I'd like to do a slider up ... (on showthread pages)
      
Reply to Thread
Results 1 to 7 of 7
  1. #1 Altitude question 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    Object: 600' stack, elevator, nice landing area. Problem-Security. I'd like to do a slider up but most of the people I've jumped with say 650' is their usual min. for slider up. With this stack a "quieter" slider up on the side away from the guard house would be preferable to the crack from a slider down. Second question, what size pilot chute would you recommend for a slider up, 3 second delay? Mojo 240 canopy.
    Thanks.
    Reply With Quote  
     

  2. #2 RE: Altitude question 
    I Support BLiNC Magazine (Silver)
    Join Date
    Dec 1969
    Location
    various
    Posts
    65
    600 ft is plenty high for a mesh jump.

    i'd recommend a 42" - 45" zp pc with a 3 second delay when using the mojo.

    remember chances for an off-heading opening are increased when using that slider thingie,
    and
    canopy time will be reduced by close to another second of ff descent.

    have fun

    kleggo
    Reply With Quote  
     

  3. #3 RE: Altitude question 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    I concur with kleggo on this one. I have done 485' slider up with a 1 - 3 second delay and a 42" pilot chute plenty of times. 650' is plenty I would say. Good luck, be safe.

    Erich
    Reply With Quote  
     

  4. #4 RE: Altitude question 
    paul
    Guest
    dude,

    42" z-po by far big enuf, even pos a 38" Up to you, if in doubt, steer toward the larger size.

    have a good jump

    later
    Reply With Quote  
     

  5. #5 RE: Altitude question 
    bps
    bps is offline
    BASE Forum Guru bps's Avatar
    Join Date
    Jun 1997
    Location
    Perigee Pro
    Posts
    242
    Hi Rick -

    600ft is plenty high for a mesh-slider jump. As others have already mentioned, the chances of an off-heading are increased when using a slider, especially at lower airspeeds.

    I've made 42 jumps from 480ft using a mesh-slider with no problems, although I must admit that this was over water which gives you a larger margin of safety.

    If I were to take a 3-second delay slider-up from a 600ft smokestack, I would use a 42"ZP pilot chute with direct and in-direct control on the slider. (direct control of the slider is rubber-banding the apex of the slider to center cell C line & indirect control refers to the primary stow)

    At any rate, good luck in your endeavor, consider all of your options, and have fun!

    Bryan
    Reply With Quote  
     

  6. #6 RE: Altitude question 
    BASE Forum Guru
    Join Date
    Jan 2003
    Posts
    11,898
    Just a thought regarding security - if you can't beat 'em, maybe you can bribe 'em. It is amazing what a case of beer or a $20 or a ? can do for the attitude of a guard making $6.00 an hour. . .
    Reply With Quote  
     

  7. #7 RE: Altitude question 
    Keith
    Guest
    I usually wait until I'm caught by the security guard before I start on the bribes, some guards don't take bribes, go figure.
    I have 2 rather old canopies that I BASE jump and when I used a mesh slider on them for a 600 foot cliff they sniveled and opened too low, although when 2 of my jumping buddies used mesh sliders on their newer and smaller canopies there they were fine. Alot depends on the age and wear on a canopy as well. Big mesh sliders are faster opening also.
    Reply With Quote  
     

Similar Threads

  1. Altitude for opening
    By imported_Mac in forum The 'Original' BASE Board
    Replies: 6
    Last Post: January 10th, 2003, 03:45 PM
  2. stowed altitude
    By guest in forum The 'Original' BASE Board
    Replies: 0
    Last Post: January 9th, 2003, 11:16 AM
  3. Slider/altitude question
    By guest in forum The 'Original' BASE Board
    Replies: 11
    Last Post: November 8th, 2001, 04:29 PM
  4. stowed altitude
    By guest in forum The 'Original' BASE Board
    Replies: 14
    Last Post: April 12th, 2000, 09:06 AM
  5. Pin Rigs at Low Altitude
    By imported_Tom Aiello in forum The 'Original' BASE Board
    Replies: 4
    Last Post: December 6th, 1999, 06:07 PM

Visitors found this page by searching for:

Nobody landed on this page from a search engine, yet!
SEO Blog
Tags for this Thread

View Tag Cloud

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24