1. Header
  2. Header-80

Welcome: If this is your first visit, start by reading the following…
Contribute
Feel free to leave comments at the bottom of a page, or become an Editors and change the actual contents.


ENTER the NEW BASE Wiki

Recent changes
If this is a return visit, click here to see what Editors have recently changed.

About the New BASE Wiki.

Gear Bags

This page is a chapter in 'BASE Wiki Other Gear'

Gear Bags: Gear bags (stash bags) are often neglected components of BASE apparel. This is odd, considering you will spend more time carrying your rig in your gear bag than you will wearing it. Having a comfortable gear bag becomes progressively more important as you make longer hikes to jump.

The majority of jumpers use a BASE specific gear bag. These are usually nothing more than a piece of cordura with two shoulder straps and a tightening cord at the opening. They are minimal, folding up really small so they’re not in the way during your jump.

What To Look For

Most people just get a gear bag with the first rig they buy, and continue to use that. If, however, you happen to shop for a gear bag, these are the things you want to consider.
  1. Quality of fabric. Is it going to tear as soon as you scrape a wall, steel girder or tree?
  2. Size. Will it fit your rig and protective gear?
  3. Waterproofness. Can the cordura protect your rig from rain or worse? Not a necessity, but it can be nice to have.
  4. Hip strap. Some gear bags have a hip strap besides the two shoulder straps. This can make them a lot more comfortable, at the expense of a little extra bulk.
  5. Shoulder strap adjustment. Can you adjust the shoulder strap length to your body size? If so, is the buckle used strong enough? If it’s flimsy plastic and it breaks, you’ll end up with a gear bag with only one shoulder strap.
  6. Elastic Cord. Some gear bags have elastic cord on the outside behind which something can be put (like your knee pads after the jump).
  7. General comfort. How wide are the shoulder straps? Are they too wide, or too narrow?

More Comfort

Even if you have a gear bag with wide shoulder straps and a hip strap, you might still look for something more comfortable for hikes longer than an hour. Check the [][/] jumping page for more advice on long hikes. As far as gear bags go, you are best off looking into the ultralight backpacking scene.



You are looking for a backpack that holds your rig, your helmet and body armor, your water and food supply, and possible camping needs if you go really remote. This requires a large backpack. Nonetheless, you also need to be able to jump without the backpack being in the way. This means it has to be compressible, i.e. it can’t have a solid frame.



Instead of folding your stash bag in the back pocket of your rig, a proper backpack will either be flattened in between the rig and your back, or you wear it the other way around on your chest. If you are planning to wear a loose jumpsuit, small amounts of gear (perhaps a stash bag and water) can be stuffed down the legs.



The two most popular companies serving the ultralight backpacking community are Gossamer and GoLite. Gosammer makes the Mariposa bag, which other jumpers have had good success with.



GoLite makes the Jam Pack which some jumpers use. People interested in this bag should read the GoLite Sucks article by Ray Jardine, who is pretty much the father of ultra light weight backpacking, as well as the inventor of cams (active climbing protection) and apparently not a bad free flier.


Jaap Suter says: I have used the Mariposa this entire summer and have nothing but good things to say about it. It’s extremely lightweight, completely unnoticeable during the jump, incredibly comfortable, and holds my full jumping and two day camping gear.

Warnings

Many people take their stash bag fold it up and put it in the pocket on the back of their rig. That is a good solution, and it is what the pocket is intended for. However, there are two potential risks with this approach.
  1. Adding extra material in between your rig and your back is going to change the fit of your rig, which can have an effect on your pin tension. If you are testing your pin tension, make sure you take that effect into account.
  2. If you have any closing cords hanging from your empty stash bag, make sure you fold them completely towards the inside. If it hangs out of the pocket on your rig, it can dangle in front of the stowed pilot chute, potentially interfering with your pitch. Good rig designs have the opening of this pocket towards the opposite side of the rig.



BLiNC Magazine strongly encourages readers to comment on its content. Read the Disclaimer and the policy on Site Naming. Posting a comment releases it in the Public Domain. These comments will be moderated. If you see inappropriate content, please notify the administrator
All rights reserved. No republication of this material, in any form or medium, is permitted without express permission of the author. All images and words are protected by U.S. and International Copyright laws. Copyright 1994-2011

This page has been seen 9,858 times.

Current Discussion: Main discussion

  1. No comments have been posted for this discussion.

Users Browsing This Page (0 members, 1 guests)