Lines
This page is a chapter in 'BASE Wiki Canopies'
Lines: All BASE ram-air canopies are seven-cell low aspect ratio. There are four suspension line attachment point groups running span-wise, labeled A, B, C, and D from the front to the rear, plus the steering line attachment points (usually 4 or 5 per side) that attach to the trailing edge of the canopy. This gives a total of 40 or 42 attachment points.
Suspension lines are made out of 600800 pound Dacron, with the brake lines usually made of heavier 900 pound Dacron. Spectra or other micro-lines commonly found on skydiving canopies are not used in a BASE environment because they have much less stretch than Dacron lines, and would therefore more efficiently transmit opening shock to the harness and jumper. Normally the lines are cascaded to reduce pack volume, meaning that the A lines are joined in a Y to the B lines and the C lines similarly to the D lines. On some canopies the center A and B lines are not cascaded due to the higher forces sustained at the center cell during opening.
Suspension lines are mostly white or black in color. The brake lines and center C and D lines (which are enclosed by the [][/] when it is used) are generally red to distinguish them from the others.
The brake line configuration varies quite a bit: from 4 to 5 attachment points to the use of 2 or 2.5 cells per side. Each configuration has its pros and cons. The lower control lines are also home to the toggles.
BLiNC Magazine strongly encourages readers to comment on its content. Read the Disclaimer and the policy on Site Naming. Posting a comment releases it in the Public Domain. These comments will be moderated. If you see inappropriate content, please notify the administrator
All rights reserved. No republication of this material, in any form or medium, is permitted without express permission of the author. All images and words are protected by U.S. and International Copyright laws. Copyright 1994-2011
Suspension lines are made out of 600800 pound Dacron, with the brake lines usually made of heavier 900 pound Dacron. Spectra or other micro-lines commonly found on skydiving canopies are not used in a BASE environment because they have much less stretch than Dacron lines, and would therefore more efficiently transmit opening shock to the harness and jumper. Normally the lines are cascaded to reduce pack volume, meaning that the A lines are joined in a Y to the B lines and the C lines similarly to the D lines. On some canopies the center A and B lines are not cascaded due to the higher forces sustained at the center cell during opening.
Suspension lines are mostly white or black in color. The brake lines and center C and D lines (which are enclosed by the [][/] when it is used) are generally red to distinguish them from the others.
The brake line configuration varies quite a bit: from 4 to 5 attachment points to the use of 2 or 2.5 cells per side. Each configuration has its pros and cons. The lower control lines are also home to the toggles.
BLiNC Magazine strongly encourages readers to comment on its content. Read the Disclaimer and the policy on Site Naming. Posting a comment releases it in the Public Domain. These comments will be moderated. If you see inappropriate content, please notify the administrator
All rights reserved. No republication of this material, in any form or medium, is permitted without express permission of the author. All images and words are protected by U.S. and International Copyright laws. Copyright 1994-2011
Categories:
Category CONTENT NEEDED, Category Gear
This page has been seen 21,299 times.
-
-
Created by onLast updated by on
-