1. Header
  2. Header-80

Welcome: If this is your first visit, start by reading the following…
Contribute
Feel free to leave comments at the bottom of a page, or become an Editors and change the actual contents.


ENTER the NEW BASE Wiki

Recent changes
If this is a return visit, click here to see what Editors have recently changed.

About the New BASE Wiki.

Premature Brake Release

This page is a chapter in 'BASE Wiki Malfunctions and Problems'

Premature Brake Release: A premature brake release occurs when the stowed toggle comes undone before you intend it to. This can happen if you don’t stow your toggles properly and the opening shock applies sufficient force to bump them off. Alternatively, you might bump them off yourself as you reach up for risers (to correct heading for example). This is more likely to happen when you use stiffened toggles.

This is a video that shows a jumper that does a double back flip, reaches up too fast and drops one (1) toggle only.
[youtube]KViOgKQwJes[/youtube]

There are 2 different schools of thought:

Throw the other toggle

By throwing the other toggle, you throw away ~25% of your canopy control. This will make the rear-riser flair symmetrical, but you will only have ~6" of flair. Prepare for a tough landing.

Use the remaining toggle

By using the other toggle, you have an extra 25% canopy control, but your flair will seem a little strange.



BLiNC Magazine strongly encourages readers to comment on its content. Read the Disclaimer and the policy on Site Naming. Posting a comment releases it in the Public Domain. These comments will be moderated. If you see inappropriate content, please notify the administrator
All rights reserved. No republication of this material, in any form or medium, is permitted without express permission of the author. All images and words are protected by U.S. and International Copyright laws. Copyright 1994-2011

This page has been seen 9,299 times.

Current Discussion: Main discussion

  1. #1
    I'm a firm believer in do not throw the other toggle. Flaring with one riser and one toggle is not difficult. Not only is the canopy easier to control, it it will shut down with greater ease. Prepare to PLF and do so if necessary.

    Flying with just rears with the brake lines trailing, is challenging. The ability to fly slower than full flight no longer exists. The control stroke is very short. Commonly people never practice riser or riser/toggle landings until a line releases for whatever reason.

    The usual scenario for over control is as follows.

    When both toggles are gone, hopefully the landing zone is large enough to accommodate. Fly to the landing zone at full speed, at 10 feet, flare too hard. The canopy first plains out then stops, stalls, and falls/flies backward. The jumper is traveling forward so he is not under the canopy yet. The jumper then falls directly onto their back from a much greater height than expected. In my experience of watching people do this, it's usually around 6 to 8 feet. That's a big fall to just back flop. Take into account the terrain. Take a back drop into rocks or rebar ... You get the picture.

Users Browsing This Page (0 members, 1 guests)