1. Header
  2. Header-80

Welcome: If this is your first visit, start by reading the following…
Contribute
Feel free to leave comments at the bottom of a page, or become an Editors and change the actual contents.


ENTER the NEW BASE Wiki

Recent changes
If this is a return visit, click here to see what Editors have recently changed.

About the New BASE Wiki.

Slidergate

This page is a chapter in 'BASE Wiki Packing'

Slidergate: Some people have sewn a regular Tailgate to the trailing edge of their slider and refer to this as a slidergate. This is not a slidergate. Manufacturers: Vertigo and Consolidated Rigging introduced the slidergate as as little loop on the trailing edge of the slider. The idea is to lark head a rubber band through it and then take a bight out of the steering lines and wrap the rubber band around it. Note that it’s just the steering lines, excluding the center C- and D-lines that you would put in a tailgate.



The main purpose of the slidergate is to help avoid line-overs, just as a Tailgate or Masking Tape do. However, many jumpers agree that with proper packing, the [Sliders]] alone is sufficient to avoid line-overs on Slider Up jumps.
As of 2005, Manufacturers: Vertigo continues to recommend using the slidergate on SliderUp jumps, in both their packing videos and by putting this loop on the sliders they sell.



Manufacturers: Consolidated Rigging on the other hand, has discontinued the slidergate and no longer recommends it. Their theory is that the slidergate distorts the trim of the canopy during the opening sequence by pulling down more than necessary on the steering lines.



The Slider Tailgate (STG) on the other hand does not distort the trim of the canopy. This set up has been working well for some jumpers. To install a STG just sew a normal tailgate in the center of the trailing edge of the slider; you can bartack it or use a super tack with a surgeon knot followed by an over-head knot. Then just trap the normal tailgate line using the “normal” tailgate rubber band.



Todo, add pictures of the slidergate.



BLiNC Magazine strongly encourages readers to comment on its content. Read the Disclaimer and the policy on Site Naming. Posting a comment releases it in the Public Domain. These comments will be moderated. If you see inappropriate content, please notify the administrator
All rights reserved. No republication of this material, in any form or medium, is permitted without express permission of the author. All images and words are protected by U.S. and International Copyright laws. Copyright 1994-2011

This page has been seen 9,217 times.

Current Discussion: Main discussion

  1. No comments have been posted for this discussion.

Users Browsing This Page (0 members, 1 guests)